Displaying And Debugging Rip - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 3-19 Configure multi-instance
Enter MBGP address family view of RIP
Remove the configuration of MBGP
address family view of RIP
All configurations in MBGP address family view will be removed after the undo
ipv4-family command is executed.
MBGP address family view applies to BGP/MPLS VPN. For related description, refer to
"MPLS VPN Configuration" chapter in module "MPLS" of this manual.
3.2.18 Configuring TRIP
Perform the following configuration in interface (except for Ethernet, ATM, loopback,
tunnel, and bridge-template interfaces) view.
Table 3-20 Configure TRIP
Enable TRIP
Disable TRIP
By default, TRIP is disabled.
TRIP is compatible with RIP-1 and RIP-2 extensions.

3.3 Displaying and Debugging RIP

After the above configuration, execute display command in all views to display the
running of the RIP configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug the RIP module.
Table 3-21 Display and debug RIP
Display the current RIP running state
and configuration information
Display
interfaces.
Display the configuration of RIP MPGP
address family
Operation
Operation
Operation
information about
3Com Corporation
3-16
Chapter 3 RIP Configuration
Command
ipv4-family [ unicast ] vpn-instance
vpn-instance-name
undo ipv4-family
vpn-instance vpn-instance-name
Command
rip triggered
undo rip triggered
Command
display rip
RIP display rip interface [ vpn-instance
vpn-instance-name ]
display
vpn-instance-name
[ unicast
rip vpn-instance
]