Enabling Is-Is On The Specified Interface; Configuring Hello Packet Stuffing Of Is-Is - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 5-2 Configure NET
Set NET
Delete NET
The format of parameter net is X...XXXXXXXXXXXX.XX, among which the first "X...X"
is the area address, the twelve Xs in the middle is the System ID of the router. The last
XX should be 00.

5.2.3 Enabling IS-IS on the Specified Interface

After enabling IS-IS, you need to specify on which interfaces the IS-IS will be enabled.
Perform the following configuration in interface view.
Table 5-3 Enable IS-IS on the specified interface
Enable IS-IS on the specified interface
Disable IS-IS on the specified interface
By default, IS-IS is disabled on interfaces.
Note:
So far, a router can enable IS-IS process on 255 interfaces at most, including logic
interfaces such as subinterfaces.

5.2.4 Configuring Hello Packet Stuffing of IS-IS

Perform the following configuration in interface view.
Table 5-4 Enable/disable Hello packet stuffing of IS-IS
Disable IS-IS to stuff Hello packets to the size of
interface MTU if their data sizes are smaller.
Restore the default to allow IS-IS to stuff Hello
packets to the size of interface MTU if their data
sizes are smaller.
Operation
Operation
Operation
3Com Corporation
5-8
Chapter 5 Integrated IS-IS Configuration
Command
network-entity net
undo network-entity net
Command
isis enable [ tag ]
undo isis enable [ tag ]
Command
isis small-hello
undo isis small-hello