Ppp And Mp Configuration Example; Pap Authentication - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 1-35 Display and debug PPP and MP
Display PPP configuration and running
state of an interface
Display MP interface information
Display information about one or all
virtual template interfaces
Display information about one or all
virtual access interfaces
Table 1-36 Display and debug PPP link efficiency mechanisms
Display statistics about TCP header
compression
Display statistics about RTP header
compression
Display statistics about Stac LZS header
compression
Enable
debugging
Enable
debugging
Clear all statistics about IP header
compression
Clear all statistics about Stac LZS
header compression

1.6 PPP and MP Configuration Example

1.6.1 PAP Authentication

I. Network requirements
As shown in Figure 1-5, routers 3Com1 and 3Com2 are interconnected through the
interface Serial3/0/0, and 3Com1 is required to authenticate 3Com2 in PAP mode.
Operation
Operation
TCP header compression
RTP header compression
3Com Corporation
Chapter 1 PPP and MP Configuration
display interface type number
display ppp
interface-type interface-num ]
display virtual-access vt [ vt-number ]
display virtual-access [va-number]
display ppp compression iphc tcp
[ interface-type interface-number ]
display ppp compression iphc rtp
[ interface-type interface-number ]
display ppp compression stac-lzs
debugging ppp compression iphc tcp
{ all | context_state
full_header | general_info }
debugging ppp compression iphc rtp
{ all | context_state
full_header | general_info }
reset ppp
[ interface-type interface-number ]
reset ppp compression stac-lzs
1-26
Command
mp [ interface
Command
| error
| error
compression iphc
|
|