Configuring Inbound/Outbound Call Restriction On The Vty User Interface - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
A common approach is to configure the Telnet command using the auto-execute
command command on the terminal so that the user may automatically connect to the
specified host.
Caution:
You should use this command with cautions because it will probably make you unable
to perform the regular configurations for the system via the terminal line to which the
command is applied. Before configuring the auto-execute command command and
saving the configuration (by executing the save command), you should make sure that
you can access the system to remove the configuration by other means.
Perform the following operations in user interface view.
Table 6-15 Set the auto-execute command
Set the automatic execution of a
command
Disable automatic command execution
The auto-execute command command that a user has configured will be
automatically executed when the user makes a new access attempt.
# For example, the telnet command will be executed automatically for the user to
access the destination host.
The steps to be executed are:
1) Execute the auto-execute command command in user interface view.
[3Com-ui4] auto-execute command telnet 10.110.100.1
2) Exit the system view and log on again. The telnet 10.110.100.1 command will be
executed automatically.
6.2.7 Configuring Inbound/Outbound Call Restriction on the VTY User
Interface
You can configure the inbound/outbound call restriction on the VTY (Telnet) user
interface through referencing an ACL.
Perform the following operations in user interface view.
Operation
3Com Corporation
6-9
Chapter 6 User Interface Configuration
Command
auto-execute command command
undo auto-execute command