3Com 3C13636 Configuration Manual page 364

3Com Router 3000 Ethernet Family
Configuration Guide
Table 3-12 Configure a static address entry
Configure a static address entry
Delete a static address entry.
By default, frames are forwarded according to the dynamic address table.
II. Enabling/disabling forwarding by using dynamic address table
Perform the following configuration in system view.
Table 3-13 Enable/disable forwarding by using dynamic address table
Enable forwarding using the
dynamic address table
Disable forwarding using the
dynamic address table
By default, the dynamic address table is used to forward frames.
III. Configuring the aging timer of the dynamic address table
The aging timer of the dynamic address table controls the time to live (TTL) of an entry
before it is deleted from the table. The entry is deleted when the timer times out.
Perform the following configuration in system view.
Table 3-14 Configure the aging timer of the dynamic address table
Configure the aging timer of the dynamic
address table.
Restore the default aging timer value.
The aging timer of the dynamic address table is in the range 10 to 1000000 seconds
and defaults to 300 seconds.
Operation
Operation
Operation
3Com Corporation
3-15
Chapter 3 Bridge Configuration
Command
bridge bridge-set mac-address mac-address
{ permit | deny } [ interface interface-type
interface-number | dlsw ]
undo bridge bridge-set
mac-address [ interface
interface-number ]
Command
bridge bridge-set learning
undo bridge bridge-set learning
Command
bridge aging-time seconds
undo bridge aging-time
mac-address
interface-type