3Com 3C13636 Configuration Manual page 100

3Com Router 3000 Ethernet Family
Configuration Guide
16) Configuring username and password used in FTP operations
You must provide the proper username and password before you perform FTP
operations.
This configuration task can be performed only in an FTP test.
Perform the following configurations in HWPing test group view.
Table 4-20 Configure username and password for FTP operations
Configure a username.
Remove the username.
Configure a password.
Remove the password.
By default, no username or password is configured.
17) Configuring name of the file on which FTP operations are performed
This configuration task is used for specifying name of the file at the server end, on
which FTP operations will be performed.
This configuration task can be performed only in an FTP test.
Perform the following configurations in HWPing test group view.
Table 4-21 Configure name of the file on which FTP operations will be performed
Configure a file name.
Remove the file name.
By default, no file name is configured.
18) Configuring the number of test packets sent for a jitter test
Jitter test is carried out for analyzing delay variations in UDP packet transmission. In
the test, the source end sends some datagrams at a regular interval (which is
configurable), upon the receipt of which the destination end stamps and return them to
the source end. The source end can thus work out the jitter delay with these datagrams
carrying timestamps. For this purpose, multiple test packets must be sent for each test.
The analysis result of a test is in direct proportion to the sent test packets. Naturally, the
more the test packets are sent, the longer the test duration will be.
This configuration task can be performed only in a jitter test.
Perform the following configurations in HWPing test group view.
Operation
Operation
3Com Corporation
4-10
Chapter 4 HWPing Configurations
Command
username name
undo username
password password
undo password
Command
filename file-name
undo filename