3Com Router 3000 Ethernet Family
Configuration Guide
Table 8-2 Disable the automatic recovery function
Disable the automatic recovery function
By default, the automatic recovery function is enabled.
8.2.3 Enabling Automatic Recovery of the Disconnected Routing Protocol
Perform the following configuration in system view.
Table 8-3 Enable the automatic recovery function
Enable the automatic recovery function
By default, the automatic recovery function is enabled.
8.3 Displaying and Debugging Route Capacity
After the above configuration, execute display command in all views to display the
running of the route capacity configuration and to verify the effect of the configuration.
Table 8-4 Display and debug route capacity
Display memory setting and state
information related to route capacity
Operation
Operation
Operation
3Com Corporation
8-3
Chapter 8 Route Capacity Configuration
Command
memory auto-establish disable
Command
memory auto-establish enable
Command
display memory [ limit ]