Msdp Integrated Networking - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
[RTA-ospf-1] quit
# Configure RTB as its MSDP peer.
[RTA] msdp
[RTA-msdp] peer 10.10.1.1 connect-interface loopback 0
# Configure Originating RP.
[RTA-msdp] originating-rp loopback0
[RTA-msdp] quit
# Configure the candidate RP and BSR.
[RTA] pim
[RTA-pim] c-rp loopback 10
[RTA-pim] c-bsr loopback 10 30

5.4.3 MSDP Integrated Networking

I. Network requirements
In the following network, Multicast Source is located in PIM-SM domain 1, and the
receivers of its Movie Online program are distributed in PIM-SM domains 2, 3, and 4.
Enable MSDP and configure an Anycast RP in PIM-SM domain 1; establish MSDP peer
relationship among RPs across PIM-SM domains; and use MBGP between domains
(For commands of this part, refer to the next chapter).
Note:
To present the configurations of MSDP and IGMP clearly, suppose no receivers exist in
PIM-SM domain 1, and the receives added to a multicast group in domains 2 through 4
are connected to the Ethernet interfaces on the routers.
For configuration of RTF, refer to the configurations of RTA and RTE.
The configurations of RTC and RTD are simpler; you need only to enable multicast
routing on them.
For configurations of RTH and RTI, refer to the configurations of RTG.
3Com Corporation
5-17
Chapter 5 MSDP Configuration