Configuring Ldp Authentication Mode; Configuring The Type Of Label To Be Distributed To The Penultimate Hop; Mpls Display And Debug - 3Com 3C13636 Configuration Manual

Router 3000 ethernet family

Hide thumbs Also See for 3C13636:

Table of Contents

3Com Router 3000 Ethernet Family

Configuration Guide

The maximum hop count defaults to 32.

2.3.6 Configuring LDP Authentication Mode

Perform the following configurations in the interface view or remote-peer view.

Table 2-16 Configure LDP authentication mode

Remove LDP authentication

This command is used at the egress to specify the type of the label to be distributed to

the penultimate hop.

Perform the following configurations in MPLS view.

Table 2-17 Configure the type of the label to be distributed to the penultimate hop

Specify at the egress the type of the

penultimate hop

Restore the default setting

explicit-null: Specifies at egress to distribute an explicit null label to the penultimate

implicit-null: Specifies at egress to distribute an implicit null label to the penultimate

non-null: Specifies at egress to distribute a normal label to the penultimate hop.

If the explicit null label is assigned to the penultimate hop, it can only reside at the

bottom of the label stack.

The label type defaults to implicit null label.

authentication

3Com Corporation

Chapter 2 MPLS Basic Capability Configuration

mpls ldp password { cipher | simple }

undo mpls ldp password

mpls label advertise { implicit-null |

explicit-null | non-null }

{ implicit-null | explicit-null | non-null }

Table of Contents

3c13636-us - router 3036 3000 series