Configuring Bims Option Support On The Dhcp Server - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Configure
interfaces
DHCP server mode and
assign addresses from
the global DHCP address
pool
Enter DHCP address pool
view
Configure
addresses for dynamic
allocation
Enable DHCP accounting
for addresses
DHCP address pool and
configure the domain for
DHCP accounting
Note:
This mode applies to the scenario where the DHCP server allocates IP addresses from
the global DHCP address pool.

9.5.14 Configuring BIMS Option Support on the DHCP Server

I. Configuration prerequisites
Before configuring the feature of BIMS option for DHCP server, complete the following
tasks:
Enable the DHCP server function and configure the address pools on the router.
Configure the DHCP clients.
Ensure that the DHCP clients, DHCP server, and BIMS server are reachable.
II. Configuring BIMS option
The following table describes the BIMS option configuration tasks.
Table 9-33 Configure BIMS option
Operation
Enter system view
Operation
specified
dhcp
to work in [ subaddress ] { all |
interface
interface-number
interface-type
interface-number ]}
dhcp server ip pool
pool-name
the IP
network
[ mask netmask ]
in the
accounting
domain-name
system-view
3Com Corporation
Command
select global
interface-type
[ to
ip-address
domain
Command
—
9-31
Chapter 9 DHCP Configuration
Remarks
Required
—
By default, DHCP
accounting is not enabled.
Remarks