3Com 3C13636 Configuration Manual page 672

3Com Router 3000 Ethernet Family
Configuration Guide
VIII. Configuring to send community attributes to a peer group
Table 6-10 Configure to send community attributes to a peer group
Configure to send community attributes
to a peer group
Not to send community attributes to a
peer group
IX. Configuring a peer group to be a route reflector client
Table 6-11 Configure a peer group to be a route reflector client
Configure a peer group to be a route
reflector client
Disable a peer group from being a route
reflector client
Only internal peer groups can be configured to be a reflector client.
By default, all IBGP peers in the AS are fully-connected and do not mutually notify IBGP
routes learned so as to avoid creating routing loops.
For detailed information on route reflector, refer to "Configure Route Reflector" section
of this manual.
X. Configuring to send the default route to a peer group
Table 6-12 Configure to send the default route to a peer group
Configure to send the default route to a
peer group
Disable sending of the default route to a
peer group
By default, the local router does not send the default route to any peer group. This
command does not require that the default route exist in the BGP routing table. Rather,
it unconditionally sends a default route with the next-hop being itself to the peer.
XI. Configuring to take the local address as the next-hop in advertising route
A BGP router can specify itself as the next hop while advertising a route to a peer
group.
Operation
Operation
Operation
3Com Corporation
6-7
Chapter 6 BGP Configuration
Command
peer
advertise-community
undo peer
advertise-community
Command
peer group-name reflect-client
undo peer group-name reflect-client
Command
peer
default-route-advertise
undo peer
default-route-advertise
group-name
group-name
group-name
group-name