Setting Date And Time; Setting System Identification; Configuring Web Browser And Telnet Login Access - 3Com OfficeConnect 3CP4144 Cli User's Manual

6-24 C 6: M
HAPTER ANUAL

Setting Date and Time

Setting System
Identification
Configuring Web
Browser and TELNET
Login Access
S
ETUP
Remember to save your configuration using the save all command before
rebooting your OfficeConnect Remote 812 so that your changes will be written to
permanent FLASH memory.
You can obtain the current date, time and system uptime using the command:
show date
The date and time information is provided in the following format:
System Date:
System UpTime:
You can set the date using the command: set date which sets the system date,
and leaves the time unchanged. The format is: dd-mmm-yyyy. The month should
be the first three characters of the month name. The year can be either 2 or 4
digits - 97 or 1997. Example: set date 01-JAN-1998
To set the time, use the command: set time which sets the system time, and
leaves the date unchanged. The format is: hh:mm:ss. The seconds (ss) field is
optional. Military time is used. For example, to set the time to 4:10 am enter the
command: set time 04:10 and to set the time to 4:10 pm enter the command:
set time 16:10.
The system name, location and contact information is useful when monitoring the
OfficeConnect Remote 812 remotely. You should choose a name, location and
contact that is appropriate for the unit.
You can view the settings using the command:
show system.
To set these parameters use the command:
set system name <name> location <location> contact <contact>
The name, location, and contact can be up to 32 characters long. For example,
set system name OCR1 location Rack4 contact SysAdmin@555-1212
Setting up a login user allows you to provide controlled access to the
OfficeConnect Remote 812 from a Web browser or through TELNET. Connecting
with a Web browser allows you to configure and monitor your unit using the
OfficeConnect Remote 812 Manager. Connecting using TELNET on a workstation
allows you to remotely manage the unit using CLI.
A default user name of root and password !root are provided by DHCP Smart
Mode and the IP Wizard during the initial installation. For secure access, you
should add a private login name and password and delete the default name.
To view the current login users, use the command:
list users
To add a login user, use the command:
add user <name> password <password>
02-MAR-1998 05:17:00
2d 08:37:54