3Com 3C13636 Configuration Manual page 780

3Com Router 3000 Ethernet Family
Configuration Guide
Note:
In practice, a network may comprise routing devices of different vendors that run
different routing protocols. In this example, the routing protocol is OSPF.
II. Network diagram
Ethernet0/0/0: Ethernet0/0/0:
10.16.1.1 10.16.1.1
Router A Router A
Figure 4-4 Network diagram for PIM-SM configuration
III. Configuration procedure
1) Configure Router A:
# Enable PIM-SM.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 0/0/0
[RouterA-Ethernet0/0/0] pim sm
[RouterA-Ethernet0/0/0] igmp enable
[RouterA-Ethernet0/0/0] ip address 10.16.1.1 24
[RouterA-Ethernet0/0/0] quit
[RouterA] interface serial 1/0/0
[RouterA-Serial1/0/0] pim sm
[RouterA-Serial1/0/0] ip address 10.16.2.1 24
[RouterA-Serial1/0/0] quit
[RouterA] interface serial 1/1/0
[RouterA-Serial1/1/0] pim sm
[RouterA-Serial1/1/0] ip address 10.16.3.1 24
Host A Host A
Serial1/0/0: Serial1/0/0:
10.16.2.1 10.16.2.1
Serial1/1/0: Serial1/1/0:
10.16.3.1 10.16.3.1
Router B Router B
Serial1/0/0: Serial1/0/0:
10.16.3.2 10.16.3.2
Serial4/0/0: Serial4/0/0:
10.16.6.2 10.16.6.2
Serial1/0/0: Serial1/0/0:
10.16.7.2 10.16.7.2
3Com Corporation
Multicast Source Multicast Source
Ethernet0/0/0: Ethernet0/0/0:
Serial1/0/0: Serial1/0/0:
10.16.4.1 10.16.4.1
10.16.2.2 10.16.2.2
Router C Router C
Serial1/1/0: Serial1/1/0:
10.16.5.1 10.16.5.1
Serial1/1/0: Serial1/1/0:
10.16.5.2 10.16.5.2
Router D Router D
4-18
Chapter 4 PIM Configuration