Setting The Router's Location (Syslocation); Setting The Source Address For Sending Traps; Setting The Snmp View - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide

9.2.10 Setting the Router's Location (sysLocation)

The argument sysLocation is a management variable of the system group in MIB and
stands for the location of a managed device.
Perform the following operations in the system view.
Table 9-11 Set the location of a router
Set the location of the router
Restore the location of the router to the
default value
# Use the following command to set the physical location of the router to hwbj.
[3Com] snmp-agent sys-info location hwbj

9.2.11 Setting the Source Address for Sending Traps

This configuration can be used to specify the source address for sending Traps.
Perform the following operations in the system view.
Table 9-12 Set the source address for sending Trap packet
Specify the source address for sending
Traps
Remove the source address for sending
Traps
# Use the following command to take the IP address of the Ethernet interface 1/0/0 as
the source address of the Trap packet.
[3Com] snmp-agent trap source ethernet 1/0/0

9.2.12 Setting the SNMP View

These configurations can be used to establish, update or delete the view information.
Perform the following operations in the system view.
Table 9-13 Set the SNMP view
Establish or update view information
Operation
Operation
Operation
3Com Corporation
9-8
Chapter 9 SNMP Configuration
Command
snmp-agent sys-info
sysLocation
undo snmp-agent sys-info location
Command
snmp-agent trap source interface-type
interface-number
undo snmp-agent trap source
Command
snmp-agent mib-view { included |
excluded } view-name oid-tree
location