Adjusting The Convergence Time Of Rip Network - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
III. Configuration procedure
1) Configure RouterA:
# Configure the interfaces Ethernet 2/0/0 and Ethernet 6/0/0.
[Router A] interface ethernet 2/0/0
[Router A-Ethernet2/0/0] ip address 192.1.1.1 255.255.255.0
[RouterA-Ethernet2/0/0] quit
[RouterA] interface ethernet 6/0/0
[RouterA-Ethernet6/0/0] ip address 192.1.2.1 255.255.255.0
# Configure RIP, and configure Ethernet 2/0/0 and Ethernet 6/0/0 to run RIP.
[Router A] rip
[Router A-rip] network 192.1.1.0
[Router A-rip] network 192.1.2.0
# Configure the interface Ethernet 6/0/0 of Router A to receive RIP packets only.
[RouterA] interface ethernet 6/0/0
[Router A-Ethernet6/0/0] undo rip output
[Router A-Ethernet6/0/0] rip input
2) Configure RouterB:
# Configure the interface Ethernet 2/0/0.
[Router B] interface Ethernet 2/0/0
[Router B-Ethernet2/0/0] ip address 192.1.1.2 255.255.255.0
# Configure RIP, and configure Ethernet 2/0/0 to run RIP.
[Router B] rip
[Router B-rip] network 192.1.1.0
[RouterB-rip] import direct
3) Configure RouterC:
# Configure the interface Ethernet 2/0/0.
[Router C] interface Ethernet 2/0/0
[Router C-Ethernet2/0/0] ip address 192.1.1.3 255.255.255.0
# Configure RIP, and configure Ethernet 2/0/0 to run RIP.
[Router C] rip
[Router C-rip] network 192.1.1.0
[RouterC-rip] import direct

3.4.2 Adjusting the Convergence Time of RIP Network

I. Network requirements
Apply RIP on RouterA, RouterB and RouterC and set the network convergence time
within 30 seconds.
3Com Corporation
3-18
Chapter 3 RIP Configuration