Enabling Rip; Enabling Rip On A Network Segment - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Disable host route
Configure route aggregation
Configure route exchange of indirectly connected RIP neighbors
Configure traffic share across RIP interfaces
3) RIP parameters configuration
Configure the RIP preference
Configure RIP timer
Configure zero field check for RIP
Specify RIP version of an interface
4) Security issues
In order to improve RIP security during routing information exchange as well as to
control the spreading area of RIP packets, following configuration is necessary.
Configure RIP packet authentication
Specify the operating state of the interface
5) RIP support for MPLS VPN
Configure multi-instance of RIP
6) Configure TRIP

3.2.1 Enabling RIP

After RIP is enabled, you can enter the RIP view.
Perform the following configuration in system view.
Table 3-1 Enable RIP and enter the RIP view
Enable RIP and enter the RIP view
Disable RIP
By default, RIP is not enabled.
Most of RIP features are configured in RIP view and a few are configured in interface
view. The features pre-configured in interface view will not take effect until RIP is
enabled. You should note that once undo rip command is executed to disable RIP, the
RIP related features configured on the interface will also be deleted.

3.2.2 Enabling RIP on a Network Segment

To flexibly control RIP operation, you can specify some interfaces and configure the
network where they are located into RIP networks, so that these interfaces can send
and receive RIP packets.
Perform the following configuration in RIP view.
Operation
3Com Corporation
3-5
Chapter 3 RIP Configuration
Command
rip
undo rip