Udp Test Of A Specified Port - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
# Step 3: Configure the IP address of an HWPing server, 169.254.10.2 for example.
[router-hwping-administrator- tcpprivate] destination-ip 169.254.10.2
# Step 4: Configure a destination port.
[router-hwping-administrator- tcpprivate] destination-port 9000
# Step 5: Configure the number of transmitted test packets.
[router-hwping-administrator- tcpprivate] count 10
# Step 6: Configure a test timeout time.
[router-hwping-administrator- tcpprivate] timeout 3
# Step 7: Enable a test.
[router-hwping-administrator- tcpprivate] test-enable
# Step 8: View the test result.
[router] display hwping result administrator tcpprivate
[router] display hwping history administrator tcpprivate
Caution:
At the destination end, you must enable HWPing Server and create an HWPing TCP
listening service by making the following configurations:
[router] hwping-server enable
[router] hwping-server tcpconnect 169.254.10.2 9000
The address and port number configured using the hwping-server tcpconnect
command on the HWPing server must be the same IP address and port number
configured in steps 3 and 4 described above.

4.5.9 UDP Test of a Specified Port

I. Introduction
UDP test on a specified port is performed to test the roundtrip time of a UDP packet.
II. Configuration procedure
Note:
Steps 1 through 4 and 7 are required for a UDP test and the remaining three steps are
optional.
3Com Corporation
4-23
Chapter 4 HWPing Configurations