3Com 3C13636 Configuration Manual page 309

3Com Router 3000 Ethernet Family
Configuration Guide
authentication, refer to the section 1.2.3 "Configuring PPP Authentication Mode and
Username and User Password".
In addition, perform the following configuration in interface view to have the interface
operate in MP mode.
Table 1-21 Set the PPP-encapsulated interface to operate in MP mode
Set the PPP-encapsulated interface to
work in MP mode
Set the interface to work in a common
PPP mode
By default, the PPP-encapsulated interface is operating in a common PPP mode.
III. Specifying the bundling mode on the virtual template interface
Username discussed here refers to the remote username received during PAP or
CHAP authentication performed when setting up a PPP connection. An endpoint
descriptor uniquely identifies a router; here, it refers to the remote endpoint descriptor
received during LCP negotiation. The system distinguishes among the MP bundles on
a virtual template interface by username and endpoint descriptor.
Perform the following configuration in VT view or Dialer view.
Table 1-22 Specify the bundling mode on the virtual template interface
Bundle
username
Bundle according to endpoint descriptor
Bundle according to both username and
endpoint descriptor
Restore the default bundle mode
By default, the system performs bundle according to the authenticated username and
terminal identifier simultaneously.
After the configurations above, the basic MP configuration is finished. The user can
configure other MP optional parameters as needed.
Operation
Operation
according to authenticated
3Com Corporation
Chapter 1 PPP and MP Configuration
ppp mp
undo ppp mp
ppp mp binding-mode authentication
ppp mp binding-mode descriptor
ppp mp binding-mode both
undo ppp mp binding-mode
1-17
Command
Command