3Com 3C13636 Configuration Manual page 54

3Com Router 3000 Ethernet Family
Configuration Guide
Table 2-5 Assign an IP address to the peer end
Assign an IP address to the peer end
II. E1/T1/E3/T3 interface configuration
Perform the following configuration in Controller e1/t1/e3/t3 view.
Table 2-6 Set working status for E1/T1/E3/T3 interface
Set E1 interface into non-channelized
mode
Bind all the timeslots of T1 interface to
serial interface
Set E3 interface into non-channelized
mode
Set T3 interface into non-channelized
mode
In addition, make the same configuration on those generated Serial interfaces.
III. Ethernet interface configuration
Enable DHCP Server to assign an IP address to the Ethernet interface corresponding
to the router to be configured.
Table 2-7 Establish the DHCP address pool and configuring the range of the dynamic
IP address
Establish the DHCP address pool or
enter the DHCP address pool view
(system view)
Configure the range of the dynamic IP
address (DHCP address pool view)
IV. Originating a Telnet/FTP connection
First confirm the interface IP address of the router to be configured, and then originate
a Telnet/FTP connection to log into it for configuration or loading configuration files.
By default, the user name and password for Telnet/FTP login are both "admin".
Operation
Operation
Operation
3Com Corporation
2-6
Chapter 2 System Maintenance Management
Command
remote address { ip-address | pool
[ pool-number ] }
Command
using e1
channel-set 0 timeslot-list 1-24
using e3
using t3
Command
dhcp server ip-pool pool-name
network ip-address [ mask netmask ]