Configuring An Msdp Mesh Group; Configuring Msdp Connection Retry Interval - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Cancel the filtering rule over received
source information
Similar to MSDP outbound filter in function, MSDP inbound filter controls the received
SA messages.. By default, the SA messages from all peers are accepted.

5.2.11 Configuring an MSDP Mesh Group

Mesh Group is useful when full connection among MSDP peers is required but SA
message flooding shall be prevented.
In a Mesh group, the SA messages from outside the group are forwarded to other
members in the group, but the SA messages from peers inside the group will not be
performed with Peer-RPF check or forwarded in the group. In this case, the overflow of
SA messages is avoided and Peer-RPF is simplified, as BGP or MBGP is not required
between MSDP peers.
Perform the following configuration in MSDP view.
Table 5-13 Configure an MSDP mesh group
Configure an MSDP peer to be a
member of an MSDP Mesh Group
Delete that member from the Group
If an MSDP peer is configured into different mesh groups, only the last configuration is
valid.

5.2.12 Configuring MSDP Connection Retry Interval

Perform the following configuration in MSDP view.
Table 5-14 Configure the MSDP connection retry period
Configure
interval
Restore the default value of MSDP
connection retry interval
By default, MSDP connection is retried at the interval of 30 seconds.
Operation
Operation
Operation
MSDP connection
3Com Corporation
5-10
Chapter 5 MSDP Configuration
Command
undo peer peer-address sa-policy
import
Command
peer peer-address mesh-group name
undo peer peer-address mesh-group
name
Command
retry
timer retry seconds
undo timer retry