Configuring The Ssh Server - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
I. Configuring the SSH server
Set the protocols supported on the current user interface
Create a local RSA key pair
Configure authentication mode for SSH user
Create SSH users
Set an interval for updating the server key (optional)
Set the timeout time of SSH authentication (optional)
Set maximum number of SSH authentication retries
Enter public key view
Enter public key edit view
Exit public key edit view
Assign public key for SSH user
Configure a service type for an SSH user
Set SSH version compatibility (optional)
II. Configuring the SSH client
Enable the SSH client
Configure public key to server associations
Configure SSH server first-time authentication

11.6.3 Configuring the SSH Server

I. Setting the protocols supported on user interface
This configuration is used to specify the protocols supported by the system in user
interface view. By default, the system supports Telnet and SSH. If SSH is enabled but
the local RSA key is not configured, the user cannot login through SSH. The
configuration will take effect in next login.
Perform the following operation in User interface view of VTY type.
Table 11-15 Set the protocols supported by system in user interface
Set the protocols supported by system in
user interface
Operation
3Com Corporation
11-17
Chapter 11 Terminal Services
Command
protocol inbound { all | pad | ssh |
telnet }