3Com 3C13636 Configuration Manual page 563

3Com Router 3000 Ethernet Family
Configuration Guide
10.1.2.2
10.1.3.2
BandWidth:48:75:1
Packets:47:74:1
Flows:0:0:0
The output indicates that load is shared on the three interfaces based on default
bandwidth.
View statistics about load sharing after you configure bandwidth-based unbalanced
load sharing on Router A.
II. Network diagram
Router A Router A
Figure 1-3 Configure bandwidth-based unbalanced load sharing
III. Configuration procedure
1) Configure Router A
# Configure bandwidth-based load sharing on three interfaces.
[Router A] interface ethernet 0/0/0
[Router A-Ethernet0/0/0] loadbandwidth 200
[Router A-Ethernet0/0/0] quit
[Router A] interface Atm 1/0/0
[Router A-Atm 1/0/0] loadbandwidth 100
[Router A-Atm 1/0/0] quit
[Router A] interface serial 2/0/0
[Router A-serial 2/0/0] loadbandwidth 300
[Router A-serial 2/0/0] quit
# View the load bandwidth ratio between the three interfaces.
[Router A] display loadsharing ip ad 10.2.1.0 24
There are/is totally 3 route entry(s) to the same destination network.
Nexthop
10.1.2.2
10.1.1.2
10.1.3.2
BandWidth:1:2:3
1193501 155000
15914 2048
eth0/0/0 eth0/0/0
atm1/0/0 atm1/0/0
WAN WAN
serial2/0/0 serial2/0/0
Packet(s) Bandwidth[KB] Flow(s)
142824 100
285648 200
428472 300
3Com Corporation
Chapter 1 IP Routing Protocol Overview
0
0
serial0/0/0 serial0/0/0
10.2.1.0 10.2.1.0
Router B Router B
0
0
0
1-8
Atm1/0/0
Serial2/0/0
Interface
Atm1/0/0
Ethernet0/0/0
Serial2/0/0