Enabling/Disabling Ldp On Interface; Configure Ldp Extended Discovery Mode - 3Com 3C13636 Configuration Manual

Router 3000 ethernet family

Hide thumbs Also See for 3C13636:

Table of Contents

3Com Router 3000 Ethernet Family

Configuration Guide

Table 2-7 Enable/disable LDP view

By default, LDP is disabled.

2.3.2 Enabling/Disabling LDP on Interface

To make the interface be of MPLS function, it is necessary to enable the LDP of

interface in the interface view. Then the interface is capable of establishing LDP

session and forwarding labeled packet.

Disabling LDP function will delete LDP peer, delete LSP tunnel, close TCP connection,

interrupt peer LDP session, stop sending HELLO packets, and stop labeled packet

Perform the following configurations in the interface view.

Table 2-8 Enable/disable LDP on interface

Enable LDP function on interface

Disable LDP function on interface

By default, the interface MPLS function is disabled.

It is to create extended discovery mode, to set up sessions with peers not directly

connected to the link.

I. Entering remote-peer mode

Perform the following configurations in the system view.

Table 2-9 Enter the extended discovery mode

Enter the extended discovery mode

Delete the corresponding remote-peer

There is no default remote-peer.

3Com Corporation

Chapter 2 MPLS Basic Capability Configuration

undo mpls ldp

mpls ldp enable

mpls ldp disable

mpls ldp remote-peer index

undo mpls ldp remote-peer index

Table of Contents

3c13636-us - router 3036 3000 series