3Com 3C13636 Configuration Manual page 79

3Com Router 3000 Ethernet Family
Configuration Guide
II. Resetting device
Perform the following operations in user view.
Table 2-29 Reset device
Clear all the stored alarm information
III. Configuring device
Perform the following operations in system view.
Table 2-30 Configure device
Upgrade a file in an in-service way
Enable scheduled rebooting on the
router and set rebooting date and time
Enable scheduled rebooting on the
router and set delay value
Remove
scheduled rebooting
Note:
After you configure the schedule reboot at command, tuning system time with the
clock command or through NTP will void the scheduled reboot setting you made.
The same applies to the schedule reboot delay command.
Upon the configuration of the schedule reboot at command, a timer starts. This
timer is cyclic and measured in minutes. For example, if you set at 12:05:26 to have
the router reboot at 12:06:00, the router will reboot at 12:06:26 instead of 12:06:00.
IV. Configuring hot-swapping pre-processing
Perform the following operations in user view.
Table 2-31 Configure hot-swapping pre-processing
Configure hot-swapping pre-processing
Remove hot-swapping pre-processing
Operation
Operation
parameter setting
Operation
3Com Corporation
2-31
Chapter 2 System Maintenance Management
Command
reset alarm urgent
Command
upgrade [ bootrom | pico-code |
logic ] filename
schedule reboot at time [ date ]
schedule reboot
minutes }
for
undo schedule reboot
Command
remove slot slotnum
undo remove slot slotnum
delay { time |