Enabling Is-Is; Configuring Net - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Configure Router Type
Set to Generate the Default Route
Configure IS-IS Authentication Password
Configure Route Aggregation
Configure Overload Flag Bit
Configure to Ignore the LSP Checksum Errors
Configure to Log the Peer Changes
Configure LSP Refresh Interval
Configure Lifetime of LSP
Set the SPF Calculation Interval
Set SPF Fragmented Calculation
Set SPF to Release CPU Actively
Enable/Disable the Interface to Send Packets
Configure IS-IS to Redistribute Routes from Other Protocols
Configure IS-IS Route Filtering
Configure the Preference of IS-IS Protocol
Configure IS-IS Routing Leak
Reset IS-IS Data Structure
Reset the Specified IS-IS Peer

5.2.1 Enabling IS-IS

To enable IS-IS protocol, you must create an IS-IS routing process and activate it on
the interface, which may associate with other routers.
Perform the following configuration in system view.
Table 5-1 Enable IS-IS
Enable IS-IS routing process and enter
the IS-IS view
Delete IS-IS routing process
The parameter tag is an identifier in an IS-IS process. In the current version, only one
IS-IS process is enabled.
By default, the IS-IS routing process is disabled.

5.2.2 Configuring NET

Network Entity Titles (hereinafter referred to as NETs) defines the current IS-IS area
address and the system ID of the router.
Perform the following configuration in IS-IS view.
Operation
3Com Corporation
5-7
Chapter 5 Integrated IS-IS Configuration
Command
isis [ tag ]
undo isis [ tag ]