Configuring Destination Servers; Displaying And Debugging The Udp Helper Configuration - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide

7.2.3 Configuring Destination Servers

After enabling UDP helper in system view, you can configure one or multiple (up to 20)
servers on an Ethernet interface to have the UDP broadcasts received on the interface
forwarded to the server or servers.
Perform the following configuration in Ethernet interface view.
Table 7-4 Configure/delete the server to which UDP broadcasts are forwarded
Configure the destination server to
which the UDP broadcasts received on
the interface are forwarded
Delete the destination server to which
the UDP broadcasts received on the
interface are forwarded
By default, no destination server is available.

7.3 Displaying and Debugging the UDP Helper Configuration

After completing the above configuration tasks, execute the display command in any
view to view the destination servers available with UDP Helper and to verify the effect of
the configurations.
Execute the debugging command in user view to debug UDP helper.
Table 7-5 Display and debug UDP Helper
Display
associated with the specified or all
Ethernet interfaces
Enable UDP Helper debugging
Disable UDP Helper debugging
Operation
Operation
the destination servers
3Com Corporation
Chapter 7 UDP Helper Configuration
udp-helper server ip-address
undo udp-helper server [ip-address ]
display udp-helper server [ interface
number ]
debugging udp-helper { event | packet
[ receive | send ] }
undo debugging udp-helper { event |
packet [ receive | send ] }
7-3
Command
Command