Command Lines for Port Configuration
Command Lines for Port Configuration
This table provides detailed information about the CLI commands for port configuration.
Feature
Port Control
Switch(config-if)# shutdown
Port1 Link Change to DOWN
interface fastethernet1 is shutdown now.
Port Control –
Switch(config-if)# no shutdown
State
Port1 Link Change to DOWN
Port1 Link Change to UP
interface fastethernet1 is up now.
Switch(config-if)# Port1 Link Change to UP
Switch(config)# interface fa1
Port Control –
Auto
Switch(config-if)# auto-negotiation
Negotiation
Auto-negotiation of port 1 is enabled!
Switch(config-if)# speed 100
Port1 Link Change to DOWN
set the speed mode ok!
Switch(config-if)# Port1 Link Change to UP
Port Control –
Force Speed/
Duplex
Switch(config-if)# duplex full
Port1 Link Change to DOWN
set the duplex mode ok!
Switch(config-if)# Port1 Link Change to UP
Switch(config-if)# flowcontrol on
Flowcontrol
Port Control –
Flow Control
Switch(config-if)# flowcontrol off
Flowcontrol
50 - RocketLinx ES7506 User Guide: 2000529 Rev. E
on for port 1 set ok!
off for port 1 set ok!
Command Line
-> Disable port state
-> Enable port state
Command Lines for Port Configuration