Table of Contents
Advertisement
Connect the Ethernet Ports
You can use the following information to connect standard Ethernet cables between the RocketLinx ES7506 10/100BASE-TX
Ethernet ports and the network nodes. The Fast Ethernet ports support 10BASE-T and 100BASE-TX, full- or half-duplex
modes.
Ports 1-4 are Fast Ethernet 10/100BASE-TX PoE ports that are IEEE 802.3af (PoE) compliant with Standard, Manual, and
Ultra mode support and provides forced power. The following table shows the RJ45 PoE pin-out assignment.
All the Fast Ethernet ports automatically detect the signal from the connected devices to negotiate the link speed and duplex
mode. Auto MDI/MDIX allows you to connect another switch, hub, or workstation without changing straight-through or
crossover cables. Crossover cables cross-connect the transmit lines at each end to the received lines at the opposite end.
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Connect the Ethernet Ports
DIN Rail Mounting
2 DIN rail clips and 4 screws were shipped with the ES7506.
Use the screws to attach the DIN rail clip to the wall-mount
plate.
10/100BASE-TX PoE Pin-Out
1
2
3
4, 5
6
7, 8
Router or PC
3 RD+
6 RD-
1 TD+
2 TD-
Straight-Through Cabling
RX +
RX -
TX +
Vport+
TX -
Vport-
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Crossover Cabling
RocketLinx ES7506 User Guide: 2000529 Rev. E - 9
Hardware Installation
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Advertisement
Table of Contents
