Table of Contents
Advertisement
Feature Configuration
This section explains how to configure the RocketLinx ES7506 software features. There are four ways to access the
RocketLinx ES7506. For information about accessing a configuration method, see the appropriate subsections.
•
Serial console
(Using the Serial Console
•
Web browser
(Configuration Using the Web Interface
•
Telnet
(Using a Telnet Console
This section discusses the configuring these software features:
•
Command Line Interface Introduction
•
Basic Setting
on Page 31
•
Port Configuration
on Page 46
•
Network Redundancy
•
VLAN
on Page 70
•
Traffic Prioritization
•
Multicast Filtering
on Page 78
•
SNMP
on Page 82
•
Security
on Page 86
•
Monitor and Diag
on Page 96
•
Device Front Panel
on Page 103
•
Save to Flash
on Page 104
•
Logout
on Page 104
Command Line Interface Introduction
The Command Line Interface (CLI) is the user interface to the RocketLinx ES7506 embedded software. You can view the
system information, show the status, configure the switch, and receive a response back from the system by keying in a
command.
There are several different command modes. Each command mode has its own access ability, available command lines and
uses different command lines to enter and exit. These modes are:
•
User EXEC Mode
on Page 26
•
Privileged EXEC Mode
•
Global Configuration Mode
•
(Port) Interface Configuration
•
(VLAN) Interface Configuration
Refer to
Configuration Using the Command Line Interface (CLI)
Feature Configuration
on Page 21)
on Page 23)
on Page 59
on Page 72
on Page 26
on Page 27
on Page 28
on Page 29
on Page 17)
on Page 21 on Page to access the CLI.
RocketLinx ES7506 User Guide: 2000529 Rev. E - 25
Advertisement
Table of Contents
