Table of Contents
Advertisement
Port Configuration
State
Speed/Duplex
Flow Control
Apply
Technical Tip:
If both ends are not at the same speed, they cannot link with each other. If both ends are not in the
same duplex mode, they are connected by half-duplex mode.
Port Control
You can enable or disable the state of this port. Once you click Disable, the
port stops to link to the other end and stops to forward any traffic. The default
setting is Enable which means all the ports are workable when you receive
the RocketLinx ES7506.
You can configure port speed and duplex mode of this port. Below are the
selections you can choose:
•
Fast Ethernet Port 1~6 (fa1~fa6)
-
Auto Negotiation
-
10M full-duplex (10 Full)
-
10M half-duplex (10 Half)
-
100M full-duplex (100 Full)
-
100M half-duplex (100 Half)
Note: The default mode is Auto Negotiation mode.
Symmetric means that you need to activate the flow control function of the
remote network device in order to let the flow control of that corresponding
port on the switch to work.
Disable means that you do not need to activate the flow control function of
the remote network device, as the flow control of that corresponding port on
the switch works.
Click Apply to apply the settings.
Note: You must Save the settings (Page 104), if you want to maintain these
settings if the RocketLinx ES7506 is powered off.
Description
RocketLinx ES7506 User Guide: 2000529 Rev. E - 47
Port Control
Advertisement
Table of Contents
