Table of Contents
Advertisement
Admin Password
Switch Setting
Apply
Admin Password
You can change the user name and the password here to enhance security.
Admin Password
You can enter a new user name here. The default setting is
User name
admin.
You can enter a new password here. The default setting is
Password
admin.
Confirm
You need to type the new password again to confirm it.
Password
Click Apply to apply the settings.
Note: You must Save the settings (Page 104), if you want
Apply
IP Configuration
This function allows you to configure the switch's IP address settings.
IP Configuration
You can select to Enable or Disable the DHCP Client function.
When the DHCP Client function is enabled, an IP address is
assigned to the switch from the network's DHCP server. In this
DHCP Client
mode, the default IP address is replaced by the one assigned by
DHCP server. If DHCP Client is disabled, then the IP address
that you specified is used.
You can assign the IP address reserved by your network for the
RocketLinx ES7506. If the DHCP Client function is enabled,
IP Address
you do not need to assign an IP address to the RocketLinx
ES7506, because it is overwritten by the DHCP server and dis-
plays here. The default IP is 192.168.250.250.
You can assign the subnet mask for the IP address here. If the
DHCP Client function is enabled, you do not need to assign the
subnet mask. The default Subnet Mask is 255.255.255.0.
Subnet Mask
Note: In the CLI, the enabled bit of the subnet mask is used to
32 - RocketLinx ES7506 User Guide: 2000529 Rev. E
Click Apply to apply the settings.
Note: You must Save the settings (Page 104), if you want to maintain these settings if the
RocketLinx ES7506 is powered off.
Description
to maintain these settings if the RocketLinx ES7506
is powered off.
Description
represent the number displayed in the web management
interface. For example, 8 represents: 255.0.0.0,16
represents: 255.255.0.0, 24 represents: 255.255.255.0.
Description
Admin Password
Advertisement
Table of Contents
