Table of Contents
Advertisement
Feature Configuration
(Port) Interface Configuration
Type interface IFNAME in global configuration mode. You can then enter Interface Configuration mode. In this mode, you
can configure port settings.
The port interface name for Fast Ethernet port 1 is fa1, Fast Ethernet 7 is fa7. Type the interface name accordingly, when you
want to enter certain interface configuration mode.
Type exit to leave.
Type ? to see the command list
Available command lists of the Port Interface Configuration mode.
Switch(config)# interface fa1
Switch(config-if)#
auto-negotiation
description
duplex
end
exit
flowcontrol
list
loopback
mac
mdix
no
poe
qos
quit
rate-limit
shutdown
spanning-tree
speed
switchport
28 - RocketLinx ES7506 User Guide: 2000529 Rev. E
Enable auto-negotiation state of a given port
Interface specific description
Specify duplex mode of operation for a port
End current mode and change to enable mode
Exit current mode and down to previous mode
Set flow-control value for an interface
Print command list
Specify loopback mode of operation for a port
MAC interface commands
Enable mdix state of a given port
Negate a command or set its defaults
Configure Power over Ethernet
Quality of Service (QoS)
Exit current mode and down to previous mode
Rate limit configuration
Shutdown the selected interface
spanning-tree protocol
Specify the speed of a Fast Ethernet port
Set switching mode characteristics
(Port) Interface Configuration
Advertisement
Table of Contents
