Table of Contents
Advertisement
Power Over Ethernet Control
Power Mode
Power Limit
PD Status Detection
PD Status Detection
IP Address
Cycle Time(s)
Apply
PoE Control
There are three power modes available for each port.
•
Standard mode will deliver power following the IEEE 802.3af
specification.
•
Manual mode allows the user to specify the wattage limit
delivered to an IEEE 802.3af device.
•
Ultra mode should be used for IEEE802.3at power requirements
and allows the user to configure the wattage limit above 15.4
watts.
Note: To deliver higher amounts of power the RocketLinx ES7506
must be powered with a 55VDC power supply.
When delivering more than 15.4W of power, ensure the
RocketLinx ES7506 is mounted on panel capable of
dissipating heat. Also ensure the temperature where the
RocketLinx ES7506 is located is kept under 60
power above 15.4W will cause the RocketLinx ES7506 to
generate more heat.
The limitation of the output power (watts) range is standard mode: N/
A, Manual mode: 0.44 - 15.4W, and Ultra mode: 0.44 - 30W.
Enable/Disable PD Status Detection function.
Type in the IP address that you want to detect.
This is the gap per detection in seconds.
Click Apply to apply the settings.
Note: You must Save the settings (Page 104), if you want maintain
these settings if the RocketLinx ES7506 is powered off.
DO NOT TOUCH DEVICE SURFACE DURING
PoE PROGRESS HIGH POWER FEEDING.
Description
°
RocketLinx ES7506 User Guide: 2000529 Rev. E - 53
PoE Control
C. Delivering
Advertisement
Table of Contents
