Table of Contents
Advertisement
Power over Ethernet
Power over Ethernet
Power over Ethernet is one of the key features of RocketLinx ES7506.It supports IEEE 802.3at higher power capabilities and
is in compliance with IEEE 802.3af standards. The RocketLinx ES7506 is equipped with power injectors on ports one through
four. Each port is capable of delivering 0.651mA of current.
The following commands are included in this section:
•
PoE Control
•
PoE Scheduling
on Page 54
•
PoE Status
on Page 54
•
Command Line for PoE Control
PoE Control
The power mode can be changed between IEEE 802.3af and forced via the combo box on the PoE configuration page. When
using IEEE 802.3af the RocketLinx ES7506 will provide power to any device that complies with the IEEE 802.3af
specification. If forced mode is selected power will be provided even if no Ethernet cable is plugged in. Only use forced mode
if you are attaching a device that is capable of receiving power via its Ethernet connection.
The following figure shows the Web UI interface for Power over Ethernet Control.
Power Over Ethernet Control
Powering Mode
PoE Mode
52 - RocketLinx ES7506 User Guide: 2000529 Rev. E
on Page 55
Each port's ability to deliver power can be individually enabled or
disabled using the PoE Mode combo box. You can select 802.3af or
forced.
Description
Power over Ethernet
Advertisement
Table of Contents
