Command Lines For Port Configuration - Comtrol RocketLinx ES7528 User Manual

Command Lines for Port Configuration

Command Lines for Port Configuration
This table provides detailed information about the CLI commands for port configuration.
Feature
Port Control
Port Control –
Switch(config-if)# shutdown
State
Port1 Link Change to DOWN
interface fastethernet1 is shutdown now.
Switch(config-if)# no shutdown
Port1 Link Change to DOWN
Port1 Link Change to UP
interface fastethernet1 is up now.
Switch(config-if)# Port1 Link Change to UP
Switch(config)# sfp
ddm Digital diagnostic and monitoring
Switch(config)# sfp ddm
Eject
Switch(config)# sfp ddm eject
all
Example: Switch(config)# sfp ddm eject all
Switch(config)# interface gigabitethernet10  eject port 10 SFP DDM
transceiver.
Switch(config-if)# sfp ddm eject
DDM SFP on Port 10 normally ejected.
Port Control –
Switch(config)# interface fa1
Auto
Switch(config-if)# auto-negotiation
Negotiation
Auto-negotiation of port 1 is enabled!
Port Control –
Switch(config-if)# speed 100
Force Speed/
Port1 Link Change to DOWN
Duplex
set the speed mode ok!
Switch(config-if)# Port1 Link Change to UP
Switch(config-if)# duplex full
Port1 Link Change to DOWN
set the duplex mode ok!
Switch(config-if)# Port1 Link Change to UP
54 - RocketLinx ES7528 Industrial Managed PoE Rack Mount User Guide: 2000509 Rev. A
Reject DDM SFP
All DDM interface
DDM SFP on Port 9 normally ejected.
DDM SFP on Port 9 normally ejected.
All DDM SFP normally ejected.
Command Line
-> Disable port state
-> Enable port state
 eject SFP DDM transceiver
Command Lines for Port Configuration