Comtrol ES7506 User Manual page 94

CLI Commands for Warnings
Event Selection
Event Selection
Example:
Cold Start event
Example:
Link Up event
Display
Syslog Configuration
Local Mode
Server Mode
Both
Disable
94 - RocketLinx ES7506 User Guide: 2000529 Rev. E
Switch(config)# warning-event
coldstart
warmstart
linkdown
linkup
authentication
fault-relay
poe-powering
power
super-ring
time-sync
Switch(config)# warning-event coldstart
Set cold start event enable ok.
Switch(config)# warning-event linkup
[IFNAME] Interface list, ex: fastethernet1 or gi1
Switch(config)# warning-event linkup fa5
Set fa5 link up event enable ok.
Switch# show warning-event
Warning Event:
Cold Start: Enabled
Warm Start: Disabled
Authentication Failure: Disabled
Link Down: fa4-5
Link Up: fa4-5
Power Failure:
Super Ring Topology Change: Disabled
Fault Relay: Disabled
Time synchronize Failure: Disabled
PoE Powering: fa1-4
Switch(config)# log syslog local
Switch(config)# log syslog remote
192.168.250.33
Switch(config)# log syslog local
Switch(config)# log syslog remote 192.168.250.33
Switch(config)# no log syslog local
Switch cold start event
Switch warm start event
Switch link down event
Switch link up event
Authentication failure event
Switch fault relay event
Switch PoE powering or unpowered event
Switch power failure event
Switch super ring topology change event
Switch time synchronize event
CLI Commands for Warnings