Replacement - HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual

FRU Removal and Replacement
6. Perform one of the following to inspect the Event Log:

Replacement

To replace an SFP optical transceiver:
1. Remove the replacement transceiver from its packaging.
2. Insert the transceiver into the port receptacle, then engage the locking
3. Perform an external loopback test on the port. Refer to
4. Reconnect the fiber-optic jumper cable:
5. Ensure the amber LED adjacent to the port transceiver is extinguished. If the
6. Perform one of the following to inspect the Event Log:
196
b. Grasp the wire locking bale and pull the transceiver from the port
receptacle.
— If at a Web browser connected to the EWS interface, click the Log tab at
the Monitor panel. The Event Log displays. An event code 513 (SFP
optics hot-removal completed) displays in the log.
— If at the HAFM appliance, open the Hardware View and choose Logs >
Event Log. The Event Log displays. An event code 513 (SFP optics
hot-removal completed) displays in the log.
mechanism by rotating the wire locking bale up or down 90 degrees.
Tests" on page 160 for instructions. If the test fails, go to
MAP" on page 32 to isolate the problem.
a. Remove the protective cap from the cable connector and the protective
plug from the port's optical transceiver. Store the cap and plug in a suitable
location for safekeeping.
b. Clean the jumper cable and transceiver connectors. Refer to
Fiber-Optic Components" on page 167 for instructions.
c. Insert the keyed LC cable connector into the port's optical transceiver.
amber LED is illuminated, go to
isolate the problem.
— If at a Web browser connected to the EWS interface, click the Log tab at
the Monitor panel. The Event Log displays. Ensure an event code 510
(SFP optics hot-insertion initiated) displays. If the event code does not
appear in the log, go to
problem.
"MAP 0000: Start
"MAP 0000: Start MAP" on page 32 to isolate the
"Perform Loopback
"MAP 0000: Start
"Clean
MAP" on page 32 to
Edge Switch 2/24 Service Manual