HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 126

Diagnostics
6
Reboot the HAFM appliance and perform system diagnostics.
1. At the Windows 2000 desktop, click Start at the left side of the task bar
2. Click the Shut Down option from the list box and click OK. The HAFM
3. Wait approximately 30 seconds and press the power ( ) button on the LCD
Boot from LAN?
Figure 35: LCD Panel During Boot Sequence
4. After successful POST completion, the LCD panel displays a Welcome!!
128
(bottom of the desktop), then click Shut Down. The Shut Down Windows
dialog box displays.
appliance powers down.
panel to power on the HAFM appliance and perform POSTs. During POSTs:
a. The green LCD panel illuminates.
b. The green HDD LED blinks momentarily, and processor speed and
random-access memory information display momentarily at the LCD
panel.
c. After a few seconds, the LCD panel displays the following message
pertaining to boot sequence selection
Press <Enter>
d. Ignore the message. After ten seconds, the HAFM appliance performs the
boot sequence from BIOS. During the boot sequence, the HAFM
appliance performs additional POSTs and displays the following
operational information at the LCD panel:
— Host name.
— System date and time.
— LAN 1 and LAN 2 IP addresses.
— Fan rotational speed.
— CPU temperature.
— Hard disk capacity.
— Virtual and physical memory capacity.
message, then continuously cycles through and displays HAFM appliance
operational information.
(Figure 35):
Edge Switch 2/24 Service Manual