Running System Diagnostics - Compaq 226824-001 - ProLiant - ML750 Setup And Installation Manual

3-14 Compaq ProLiant ML750 Servers Setup and Installation Guide

Running System Diagnostics

10. Replace the access panels and reconnect all power cords.
11. Power on the server and check the LEDs or the symptom again.
12. If the problem is not resolved, contact Compaq or your service provider.
1. Make sure there is good facility power applied to the server.
2. With the server in Standby, check the LEDs on the power supplies:
G
The top LED should be OFF (clear).
G
The bottom LED should be ON (solid green).
3. Turn on the power to the machine. During the Power-On Self-Test
(POST), press F10 to start the Compaq System Diagnostics.
4. At the Main Menu, select Diagnostics and Utilities.
5. At the Diagnostics and Utilities menu, select Test Computer.
6. Select a test:
G
Quick Check runs a set of tests. The time required for the tests
depends on the server configuration; it could require up to two hours.
Quick Check does require less time than the Automatic Diagnostics.
G
Automatic Diagnostics runs a complete set of system tests. These
tests could require several hours.
If errors occur, refer to the "Diagnostics Tools" chapter of the Compaq Servers
Troubleshooting Guide.