Replacing The Hot-Plug Redundant Front Processor Fans (Fan 3) - Compaq 226824-001 - ProLiant - ML750 Setup And Installation Manual
Compaq proliant ml750 server setup and installation guide
Hide thumbs
Also See for 226824-001 - ProLiant - ML750:
- User manual (147 pages) ,
- Basics manual (44 pages) ,
- Safety information manual (204 pages)
Table of Contents
Advertisement
4-66 Compaq ProLiant ML750 Servers Setup and Installation Guide
Replacing the Hot-Plug Redundant Front Processor
Fans (Fan 3)
WARNING: To reduce the risk of injury or damage to the equipment, do not
remove the internal processor fan assembly (Fan 4) while the server is powered
up. Fan 4 is NOT hot-plug capable. For information on placing the server in
Standby and disconnecting the power cords, see the "Powering Down the
Server" section in Chapter 3.
1. Pull the ejector lever out
fans outward
, and remove the fans from the chassis.
Figure 4-59. Releasing the hot-plug redundant front processor fans from the
chassis
to release the front processor fans, pivot the
2
1
Advertisement
Table of Contents
Troubleshooting
