Compaq 226824-001 - ProLiant - ML750 Setup And Installation Manual page 177

To run the ROM-Based Setup Utility:
1. Boot the computer from the Compaq SmartStart and Support
Software CD.
2. From the Compaq System Utilities screen, select Run ROM-Based
Setup Utility.
3. Select Continue.
4. Select Review or Modify Hardware Settings and press Enter.
5. Select Step 3: View or Edit Details and press Enter.
6. Scroll down until you find the section entitled Embedded Compaq IMD
Module.
7. Highlight the field to be modified. You must press Enter to edit the
highlighted item, then type the text for that field. After entering the text,
press Enter to accept the modifications. Each field is discussed in detail
in the "Customizing Management Display Fields" section.
8. Repeat step 7 for each menu item to be modified.
9. Press F10 to exit the View or Edit Details screen.
10. Select Step 5: Save and Exit.
11. At the server prompt to Save the Configuration and Restart the
Computer, select OK=Enter. The changes you have entered will not be
displayed on the Display Panel until you reboot the computer. Standard
IMD fields are defined in the "Navigating the Menus" section later in
this chapter.
12. If you have an older version of the ROM-Based Setup Utility installed
on your hard drive, you will be asked if you would like to upgrade your
system partition. You should upgrade your ROM-Based Setup Utility at
this time.
Integrated Management Log 7-3