Compaq 226824-001 - ProLiant - ML750 Setup And Installation Manual page 103

To install Compaq DIMMs:
1. If the server is on, place it in Standby mode and disconnect the power
cords. See the "Powering Down the Server" section in Chapter 3.
2. Remove the right side access panel. See "Removing the Right Side
Access Panel" section in Chapter 3.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
3. Remove the memory expansion board. See the "Removing and
Replacing the Memory Expansion Board" section earlier in this chapter.
4. Place the memory expansion board, components facing up, on a flat
surface.
CAUTION: The ejectors prevent the memory expansion board from lying
completely flat. Inserting a DIMM without counter pressure applied behind the
socket to the back of the expansion board can cause the memory expansion
board to flex and could result in damage. Always support the memory expansion
board or apply counter pressure while inserting a DIMM.
Installing Hardware Options 4-23