9. Align the new processor, heat pipe facing toward the rear of the server,
with the processor slot. Install the processor, pushing firmly until fully
seated
and secure by rotating the ejector levers inward
NOTE: Place thumbs on either side of the heat pipe to avoid touching it.
Figure 4-12. Installing the processor
10. Fit the main processor air baffle into the slots at the front of the
server
, and snap the baffle in at the rear of the server
1
Figure 4-13. Replacing the main processor air baffle
11. Replace the right side access panel and reconnect the power cords. See
the "Removing the Right Side Access Panel" section in Chapter 3.
Installing Hardware Options 4-13
2
1
1
2
2
.
.