2. From the rear of the server, locate and remove the blanking panel from
the available power supply cage by removing the retaining screw
lifting the blanking panel from its position
Figure 4-2. Removing the power supply cage blanking panel
CAUTION: Do not leave the blanking panel off for prolonged periods if no power
supply is installed. System airflow could be adversely affected and result in hard
drive overheating.
3. Remove the protective cover from the new power supply connector.
Keep the cover for future handling.
4. Lower the handle on the new hot-plug power supply.
2
1
Installing Hardware Options 4-3
.
and