Compaq 226824-001 - ProLiant - ML750 Setup And Installation Manual page 87

Processor/Processor Power Module Slots
and Bus/Core Ratio Switch Locations
Item Component
Processor Power Module Slot 1


Processor Slot 1

Processor Power Module Slot 2

Processor Slot 2

Processor Power Module Slot 3
Processor Slot 3
Processor Power Module Slot 4
Processor Slot 4

Cache Accelerator Slot 1

Cache Accelerator Slot 2

When installing new processors, it is important to follow these guidelines:
All processors must be Intel Pentium III Xeon processors. The


ProLiant ML750 server does not support Pentium II Xeon processors.
Processors must be installed starting from the slot closest to the rear of


the server (Slot 1).
Each pair of processor slots must contain processors of the same cache


size (processor slot pairs are: Slots 1 and 2, Slots 3 and 4, Slots 5 and 6,
Slots 7 and 8). If there is no match for a processor, the second slot in the
pair must be filled with a processor terminator board.
The processor pair with the lowest cache size should be installed closest


to the rear of the server. If a second pair of processors has a larger cache
size, it should be installed in the next pair of slots.
CAUTION: The server will not boot if the Intel Pentium III Xeon processors are
not the same speed.
Installing Hardware Options 4-7
Table 4-1
Item Component
Processor Power Module Slot 5

Processor Slot 5

Processor Power Module Slot 6

Processor Slot 6

Processor Power Module Slot 7
Processor Slot 7
Processor Power Module Slot 8

Processor Slot 8

Processor Bus 2 Bus/Core Ratio

Switch
Processor Bus 1 Bus/Core Ratio

Switch