Hard Reset - Tandberg Data SLR7-140 PROGRAMMER Manual

Tandberg Data
3.5.2.1.

Hard Reset

When the Drive detects a hard reset condition it will do
the following:
Release all SCSI-bus signals and go to BUS FREE.
Clear all non-completed commands
Release all SCSI-device reservations
Return all SCSI device operating modes to their saved
values (MODE SELECT) or default values (PREVENT/ALLOW
MEDIUM REMOVAL). The non-savable Log Parameters will
be cleared to zero. The savable Log Parameters will
remain unchanged, unless the Hard Reset is a result
of a Power-up condition. In this case the savable Log
Parameters will be initialized to their saved values.
Position the media to BOM - if the drive has a
cartridge inserted when the reset condition occurred.
UNIT ATTENTION condition will be set for all
Initiators (see Section 3.4. Unit Attention)
3-14 Tandberg SLR Product Line SCSI Functional Specifications
Logical Characteristics