Tandberg Data SLR7-140 PROGRAMMER Manual page 223

SLR50 Drive:
Medium Type Default Speed
SLRtape50 103 ips
SLR32 120 ips
SLRtape24 120 ips
SLR5 118 ips 0.58 MB/s
DC9250 120 ips 0.48 MB/s
Table 14-7:
SLR7 Drive:
Medium Type Default Speed
SLRtape7 105 ips
SLR5 98 ips 0.48 MB/s
Block Descriptor
Length
Tandberg Data
Low Speed
2 MB/s 52 ips
1.5 MB/s 60 ips
1.2 MB/s 60 ips
118 ips 0.58 MB/s
120 ips 0.48 MB/s
Available Tape Speeds for SLR50.
Low Speed
3 MB/s 105 ips
98 ips 0.48 MB/s
Table 14-8: Available Tape Speeds for SLR7
Legal values are numbers in the range 0..3.
The default (factory programmed) value is 0.
Note that the AVC bit (Auto Velocity Control, see
14.3.7. Device Configuration Page) has priority over
the Tape Speed field. This means that when AVC is active
the drive ignores the value of the Tape Speed field.
This field specifies the length in bytes of the block
descriptor list. Legal values are either 0 or 8. A value
of zero means that no block descriptor list is included
in the Parameter List.
14-5 Tandberg SLR Product Line SCSI Functional Specifications
Medium Speed
1 MB/s 52 ips
0.75 KB/s 60 ips 0.75 MB/s
0.6 MB/s 60 ips
118 ips 0.58 MB/s
120 ips 0.48 MB/s
Medium Speed
3 MB/s 105 ips
98 ips 0.48 MB/s
Mode Select
High Speed
1 MB/s 103 ips
120 ips 1.5 MB/s
0.6 MB/s 120 ips 1.2 MB/s
118 ips 0.58 MB/s
120 ips 0.48 MB/s
High Speed
3 MB/s 105 ips
98 ips 0.48 MB/s
2 MB/s
3 MB/s