Tandberg Data SLR7-140 PROGRAMMER Manual page 181

BYTE BIT 7
n+0 Parameter Code = 0003h
n+1
n+2 DU
n+3 Parameter Length = 04h
n+4
 Maximum Capacity Counter - Partition 0
n+7
Table 13-31: Maximum Capacity Log Parameter code 03
Parameter Code
DU
DS
TSD
ETC
TMC
LP
Parameter Length
Maximum Capacity
Counter - Partition 0
Tandberg Data
Maximum Capacity Log Parameters - Partition 0
6 5
DS TSD
The Parameter Code is set to 0003h.
The Disable Update (DU) bit will always be set to 0 to
indicate that the Drive is always free to update the
counter.
(Note: This bit can not be changed by the initiator)
The Disable Save (DS) bit is set to 1 to indicate that
the Drive does not support saving of this log parameter.
(Note: This bit can not be changed by the initiator)
The Target Save Disable (TSD) bit is set to 1 to
indicate that the Drive does not provide any Drive-
defined method for saving of this log parameter.
(Note: This bit can not be changed by the initiator)
The Enable Threshold (ETC) bit is set to 0 to indicate
that no threshold comparison will take place.
The Threshold Met Criteria (TMC) field is valid only if
ETC bit is 1 and it selects one of four possible
Threshold Met Criteria.
The default value is 11b. See the LOG SELECT command for
further description.
The List Parameters (LP) bit is set to 0 to indicate
that the parameter is a data counter.
(Note: This bit can not be changed by the initiator)
This field is set to 04h to indicate that the counter is
4 bytes wide.
This counter presents an estimation of the maximum
capacity of partition 0. This counter reflects
corresponding value of Partition Size Descriptor in Mode
Sense's - Medium Partition Page, but the count here is
scaled to kilobytes.
Any attempt by initiator to alter this counters
accumulated, threshold or control-bytes values will be
ignored.
13-34 Tandberg SLR Product Line SCSI Functional Specifications
4 3
ETC TMC
Log Sense
2 1 0
R LP