Tandberg Data MSERIES RMC Quick Reference Manual

Tandberg Data M-Series Remote Management Card
This Quick Reference Guide
explains how to install the
M-Series Remote Management
Card (RMC) into a Tandberg Data
M-Series tape library.
For your convenience, this task
has been condensed into a few
simple steps. As you perform each
step, watch for instructions that
specifically address a first-time
installation or a field replacement.
If you need help with any part of
these instructions, please contact
Tandberg Customer Support. You
can also receive help in the form of
a complete set of M-Series library
user documents in Portable
Document File (PDF) format by
going to www.tandberg.com.
Once the RMC is installed, it must
be configured using instructions
found in the Tandberg Data
M-Series Remote Management
Card User's Guide. This User's
Guide and other applicable
documentation are available in
PDF format on the CD shipped in
the Tandberg Data Field Upgrade
Kit.
N
: Adobe Acrobat Reader is
OTE
required to view and print PDF
documents. To download a free
copy of Adobe Acrobat Reader, go
to www.adobe.com.
Quick Reference Guide
STEP 1:
PREPARE FOR INSTALLATION/REPLACEMENT
a. If this is a first-time installation,
3.03 or later. For a complete list of system requirements, refer to the Tandberg
Data M-Series Remote Management Card User's Guide, P/N T6473046.
b. Make sure you have the tools recommended for this procedure:
®
--
#1 Phillips screwdriver.
--
Slotted screwdriver.
®
--
T10 TORX screwdriver. (This tool may be required to remove the outer
cover of the desktop model of the M-Series library.)
RMC
Main Installation/FRU Components
c. Take precautions to prevent electrostatic discharge (ESD). These precautions
include:
--
Wearing a properly grounded antistatic wrist strap.
--
Wearing other antistatic apparel (smock, footwear, etc.).
--
Handling library components with care and keeping the RMC in its antistatic
packaging until you are ready to install it.
C : Failure to take adequate antistatic precautions may result in
AUTION
damage to the RMC or other library components.
make sure your library has firmware version
Interconnect cable
P2
P1