Tandberg Data SLR7-140 PROGRAMMER Manual page 179

BYTE BIT 7
n+0 Parameter Code = 0002h
n+1
n+2 DU
n+3 Parameter Length = 04h
n+4
 Remaining Capacity Counter - Current Partition
n+7
Table 13-30: Remaining Capacity Log Parameter code 02
Parameter Code
DU
DS
TSD
ETC
TMC
LP
Parameter Length
Tandberg Data
Remaining Capacity Log Parameters - Current Partition
6 5
DS TSD
The Parameter Code is set to 0002h.
The Disable Update (DU) bit will always be set to 0 to
indicate that the Drive is always free to update the
counter.
(Note: This bit can not be changed by the initiator)
The Disable Save (DS) bit is set to 1 to indicate that
the Drive does not support saving of this log parameter.
(Note: This bit can not be changed by the initiator)
The Target Save Disable (TSD) bit is set to 1 to
indicate that the Drive does not provide any Drive-
defined method for saving of this log parameter.
(Note: This bit can not be changed by the initiator)
The Enable Threshold (ETC) bit is set to 0 to indicate
that no threshold comparison will take place.
The Threshold Met Criteria (TMC) field is valid only if
the ETC bit is set to 1 and it selects one of four
possible Threshold Met Criteria.
The default value is 11b. See the LOG SELECT command for
further description.
The List Parameters (LP) bit is set to 0 to indicate
that the parameter is a data counter.
(Note: This bit can not be changed by the initiator)
This field is set to 04h to indicate that the counter is
4 bytes wide.
13-32 Tandberg SLR Product Line SCSI Functional Specifications
4 3
ETC TMC
Log Sense
2 1 0
R LP